Skip to content
Clark's Garage944 · 924 · 968 · Turbo
Suspension

CV Joint Boot Check

Routine inspection procedure for CV joint boots, with criteria for determining when a boot must be replaced.

Difficulty: Easy1 min readApplies to: 924 · 924S · 944 · 944S · 944S2 · 944 Turbo · 968
Download factory PDF

Introduction

CV joint boots should be inspected every 15,000 miles.

Tools

  • Jack stands
  • Floor jack

Procedure

  1. Raise the rear of the vehicle on jack stands.
  2. Inspect the CV joint boots for signs of cracking.
  3. Squeeze the CV joint boots and inspect for grease leaking from any cracks.
  4. Replace the boot if it shows deep cracking (greater than 1 mm) OR if any grease is leaking from cracks in the boot.
Tags:cv jointbootinspectionmaintenancerear suspension

More in Suspension

944 Control Arms - General Information, Rebuilding, and Aftermarket Replacements

Overview of alloy control arm failure modes on the 944, DIY rebuild procedure using kit components, and a survey of aftermarket replacement options.

PDF944 · 944S · 944S2

Control Arm Replacement

Removal and installation procedure for front control arms on the 924/944, with torque specifications for all fasteners.

PDF924 · 924S · 944

CV Joints - General Information, Removal, Installation, and Maintenance

Complete procedure for removing, cleaning, repacking, and reinstalling 924/944 rear CV joints, including part numbers for joint kits, boot kits, and complete axles.

PDF924 · 924S · 924 Turbo

Front Sway Bar Removal and Installation

Short procedure for removing and reinstalling the front anti-roll (sway) bar on the 924/944.

PDF924 · 924S · 944