Hopp til innhold
Clark's Garage944 · 924 · 968 · Turbo
Hjuloppheng

Rear Sway Bar Removal and Installation

Short procedure for removing and reinstalling the rear anti-roll (sway) bar and drop links on the 924/944.

Vanskelighetsgrad: Enkel1 min lesingGjelder for: 924 · 924S · 944 · 944S · 944S2 · 944 Turbo · 968
Last ned fabrikk-PDF

Denne prosedyren er ikke oversatt ennå og vises på engelsk.

Tools

  • Metric socket/wrench set
  • Floor jack / jack stands

Procedure

  1. Raise the vehicle on jack stands.

  2. Removing the rear wheels simplifies the job but is not required.

  3. Remove the two bolts/nuts on either end of the sway bar that attach it to the drop links.

  4. Remove the four bolts (two on each side) that hold the sway bar to the torque tube carrier and remove the sway bar from the vehicle.

  5. Installation is the reverse of removal.

Emneord:sway baranti-roll barstabilizerrear suspensiondrop link

Mer i Hjuloppheng

944 Control Arms - General Information, Rebuilding, and Aftermarket Replacements

Overview of alloy control arm failure modes on the 944, DIY rebuild procedure using kit components, and a survey of aftermarket replacement options.

PDF944 · 944S · 944S2

Control Arm Replacement

Removal and installation procedure for front control arms on the 924/944, with torque specifications for all fasteners.

PDF924 · 924S · 944

CV Joint Boot Check

Routine inspection procedure for CV joint boots, with criteria for determining when a boot must be replaced.

PDF924 · 924S · 944

CV Joints - General Information, Removal, Installation, and Maintenance

Complete procedure for removing, cleaning, repacking, and reinstalling 924/944 rear CV joints, including part numbers for joint kits, boot kits, and complete axles.

PDF924 · 924S · 924 Turbo