Skip to content
Clark's Garage944 · 924 · 968 · Turbo
DME / Engine Management

DME Wiring Diagram — 944 Turbo

Reference page for the 944 Turbo DME (Bosch Motronic) wiring layout, with pointers to the control-unit removal, chip-installation, and parts-catalogue resources.

Difficulty: Easy1 min readApplies to: 944 Turbo

General

This page covers the wiring layout for the 944 Turbo DME control unit.

The full wiring diagrams are the factory diagram sheets for the 944 Turbo DME; the original sheets are not reproduced in this archive. For the control unit itself — its location, removal, and installation — see DME-01. For performance-chip replacement, see DME-02. The DME control unit for your exact engine is in the parts catalogue.

KLR wiring diagrams are not included here.

Tags:DMEwiring diagramengine managementMotronic

More in DME / Engine Management

DME Control Unit Chip Installation

Step-by-step procedure for opening the DME control unit (and KLR on turbos), identifying and replacing the performance chip, and reassembling, including critical notes on chip orientation and ESD precautions.

PDF944944S944 Turbo

DME Control Unit Removal and Installation

Procedure for removing and installing the DME control unit (and KLR anti-knock unit on turbo models) from early under-dash and late passenger footwell locations.

PDF944944S944 Turbo

DME Self-Diagnosis and Troubleshooting (8-valve)

A structured test-point diagnosis of the 8-valve DME (Digital Motor Electronics) fuel-injection and ignition system: equipment, safety rules, and fifteen sequenced test points covering no-start, hard-start, misfire, and poor-running faults — each with the factory pass/fail values.

944 only

DME Wiring — 944 (reference note)

Reference note on the 944 DME wiring layout — no wiring diagram is reproduced here. The sheets Clark's used were actually 911 DME diagrams only said to be similar, not confirmed 944 diagrams, so verify against factory documentation.

944924S